Search Results for:
How to Installation Guide: Fog Lights on VW Golf-Rabbit
The following document contains information related in DIY guide for installing fog lights on a MkV Volkswagen Golf or Rabbit. It supports materials both standard installation and installation with a relay in which the car has the necessary equipment to support fog lights. Fog Lamp Install This diy fog light for VW document covers materials such as Accessing the electrical system control module, Retrieving the electrical system using VAG-COM, I… 0, 2.57, 0, 1, light: 1
How to Guide: 2006 Harley Davidson Touring System Relay Circuit Wire Harness Location
The following diagram shows 2006 Harley Davidson Touring System Relay Circuit that will guide you locating the connectors wire harness of FLHX, FLHT/C/U, FLTR variant. No Wire Harness Connector Location 1 Main to Interconnect Harness Inner Fairing (right radio support bracket) 22 Right Handlebar Switches Inner Fairing (fork stem nut lock plate) 33 Ignition/light key switch Inner Fairing – under radio 78 ECM under right side co… 0, 2.57, 0, 1, light: 1
How to Test Balmar 6 Series Internal Regulator
…alternator wiring plug 2. Turn the ignition switch to the ON position 3. Connect the positive probe of your test lamp on the FIELD terminal of the wiring plug. 4. Connect the tester’s negative probe to ground. 5. The test light will illuminate if the internal regulator is working correctly. 6. If using a multi-tester, adjust the meter to read 24V DC before placing probes at the field terminal and ground. It will show approximately 3V DC if t… 0, 2.57, 0, 1, light: 1
Do It Yourself Making Cordless Microphone Receiver
After previous post about how to make a citizen band (CB) cordless microphone transmitter, it is our turn to post section about how to make its receiver. The circuit diagram of the cordless microphone receiver is shown in the following illustration. The leakage current of Dl, which is reverse biased, depends upon the infra-red light level to which it is subjected. The pulses of infra-red from the transmitter cause small increases in the leakage… 0, 2.57, 0, 1, light: 1
DIY Circuit: An Electronic Counter for your Mailbox Letters
…r 7 segment display. At first flip flop constructed by Ni and N2 and the transistor T2 is reset which has conduction, causing the word “NONE” on the display – which means ‘no mail’. If the signal light to the LDR is blocked (when there was a letter put into the mailbox), T3 will be conducted quickly and triggering the flip flop. As a result, T2 breaks-out and T1 at work then the display will show ‘post’ w… 0, 2.57, 0, 1, light: 1
