Search Results for:
How to Install: Nokia Car Kit Bluetooth Power Cable Wires and Fuses
The schematic picture below shows the power cable of Nokia Bluetooth CK-15W Car Kit, if you need to install it by yourself. The power cable has the following wires and fuses: +12V, car battery +, red Ground, car battery -, black Car radio mute, yellow Car ignition sense, blue 2A fuse 1A fuse And here are the guide steps for installing Nokia Bluetooth Car Kit Power Cable: Connect the black wire to the vehicle ground. Plug the yellow wire into… 0, 0.77, 0, 1, guide: 1
How to Do It Yourself Testing ATX Power Supply
If you need to test whether the ATX power supply is in good or bad condition, the following illustration may help you. Above are ATX power connector layout and schematic diagram guide. Now, here are steps for testing ATX Power Supply (PSU) by yourself: 1. You can identify the Power ON pin via the only green wire goes to pin 14 2. Using any piece of wire, short green wire with any other black wired ground pin If the power supply has power c… 0, 0.77, 0, 1, guide: 1
How to Redesign the Grounds and Signal Returns of Tele Harness Guitar
… to the terminal of the pot. The capasitor helps retain high frequencies as you turn the volume control down while the resistor smooths out the taper that give you more control the critical higher volume settings. Completed guide on How to Redesign the Grounds and Signal Returns of Tele Harness Guitar in pdf filetype (source: blueguitar.org) … 0, 0.77, 0, 1, guide: 1
How to Check Terminal Voltage on Nissan Vehicles Starter Circuit
The information herein describes techniques on how to perform a voltage drop test on Nissan vehicle’s starter circuit. It might be useful for locating and correcting starter circuit problems. The illustration diagram above can be a diagnostic guide in troubleshooting a starting circuit. Notes: (1) System voltage is 12.2 Volts (2) Please remove the fuel pump fuse and bleed of the fuel pressure from the fuel system (3) Check the sta… 0, 0.77, 0, 1, guide: 1
DIY Connecting Mitsubishi Eclipse Tach Adapter
…#8217;s ignition system for identifying supply wiring purposes. Once the wire has been located it is recommended to check for 12 volts using a volt meter. Connect the meter and turn the ignition On. See complete installation guide of DIY Tach Adapter for Mitsubishi Eclipse (and Eagle Talon) here (source: autometer.com) … 0, 0.77, 0, 1, guide: 1
