Search Results for:
Do Design Digital Voltmeter by Yourself
Theophilus Hello! I’m Theophilus a student at Kigali Institute of Science and Technology (KIST), in final year of Electronics and Telecommunication Enginnering.
I would like to design and implement a Digital Voltmeter using Dual-Slop Analog to-Digital Converter.
The analog input has a full scale of 10V.
The 1st step is to convert the analog input in digital output.
Binary count will count N-bit binary output. This N-bit binary will be … 0, 2.37, 0, 1, electronic: 1
How to Build a Compact and Portable Flashlight using LED
The following document contains information on how to build a 3V/9V mini flashlight LED. It will guide you for constructing a compact and portable flashlight utilizing a long lasting Light Emiting Diode (LED) by do-it-yourself. You might need the herein parts/components and tools for finishing the flashlight project:1. A white 5mm LED (3.6 forward voltage)2. A 2700 ohms resistor 3. 26 AWG hookup wire, see the AWG guide.4. A soldering iron and a… 0, 2.37, 0, 1, electronic: 1
How to Guide: Removing VW Golf/Jetta ECU
The following document provide information to guide you removing VW Golf/Jetta 1.8 Turbo, VR6, Audi 180hp and 225hp Electrical Controller Unit (ECU). ECU is a type of electronic control unit that determines the amount of fuel, ignition timing and other parameters an internal combustion engine needs to keep running. As stated in this guide, you will have to prepare 13mm socket wrench and a medium flat blade screw driver to do removing the Golf/J… 0, 2.37, 0, 1, electronic: 1
How to Multiplex Mini2440 Test Keys to GPIO Interface
The table below performs the Mini2440 test keys in order to be multiplexed to GPIO and other function interfaces. It has 6 test keys which are all CPU interrupt input signals and will be triggered a low level voltage. And here are those 6 keys: You can Multiplex Mini2440 Test Keys through CON12 as defined above. Power supply 3.3V at CON12.7 and Ground (GND) at CON12.8. (source: microarmsystems.com) … 0, 2.37, 0, 1, electronic: 1
Do It Yourself Hookup Ammeter Gauge for Internal Regulator
…n on the ignition switch. The generator light will come on. If it doesn’t, check all dash-side connections and check that the generator light bulb has not burned out. 4. Start the car. If the alternator is charging the circuit. The generator light will stay lit for several seconds before going out with a good alternator, a good battery and a tight alternator belt. The ammeter gauge should read between 10-15 amps for several minutes before … 0, 1.79, 0, 1, circuit: 1
