Home » Circuitry » Open Cut Negative Alarm Controller DIY Guide

Open Cut Negative Alarm Controller DIY Guide

Sponsored Links

Schematic below configures Dynamco one wire alarm relay controller which also known as open cut negative control. This relay controller may be suited in new Japanese and Korean vehicles.

alarm relay config

One wire alarm relay control

You can see how to configure lock/unlock from actuator to the controller. Colors of the wire (BK, BU, WT, RE, GY) are default, as seen in Dynamco’s relay sockets. Lock or unlock signals from alarm can also be reversed.



Filed in category: Circuitry, one wire alarm, relay socket, alarm wire, by Doughary Dow at December 4, 2011
Sponsored Links

«
»
You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

    Similar Category

  • DIY Circuit: An Electronic Counter for your Mailbox Letters
    Electronic Counter for Mailbox Circuit DIY
    • Does the postman was coming today? or are there any letter for today? Such questions always came out of the millions of people each day. And, as...
  • DIY How to Make an Automatic Emergency Lighting Unit
    Automatic Emergency Lighting DIY Circuit
    • This automatic emergency lighting unit use NiCad batteries in the main circuit to provide a power supply which is always ready for emergency lighting during power outages....
  • How to Perform a Starter Motor Pull-In Test DIY
    starter motor pull-in test schematic
    • Please disconnect the battery ground (—) cable before removing the starting motor. And here is your starter motor pull-in test diy guideline:
  • Do It Yourself Hookup Ammeter Gauge for Internal Regulator
    ammeter gauge charging system hookup
    • An ammeter gauge may be used in car/automotive in order to exactly monitor charging system condition. Below illustration shows hookup design schematic for ammeter gauge to be...