Home » Circuitry » How to Guide: Transmitting VGA Video Signal via CAT5 STP or UTP Cable

How to Guide: Transmitting VGA Video Signal via CAT5 STP or UTP Cable

Sponsored Links

The VGA extender is used to be applied in home or commercial applications such classroom video distribution, lecture vga extender over cat5 diy guide halls, video information displays, training system with PC and etc. It allows the VGA video signals to be transmitted up to 135 meters via 4-paris CAT5 STP or UTP cable.

The herein informations provide you with how to install CAT5 VGA extender. It outlines sections such the Recommended cable (RJ45 Pin Configuration), Switch setting (TTP111VGA-T Sync Mode Select), DIP Switch Setting (HTA-TTP111VGA-R Sync Filter Level), Troubleshooting at picture problem (No picture display, Picture not stable or disappear intermittence or no picture display, Picture tilt) and Application Tips to use CAT5 STP cable.

Complete read about Transmitting VGA Video Signal via CAT5 STP or UTP Cable can be seen in this wiring and circuitry guide of pdf filetype (source: huntcctv.com).



Filed in category: Circuitry, CAT5 VGA, VGA extender cat5, by Doughary Dow at February 14, 2010
Sponsored Links

«
»
You can leave a response, or trackback from your own site.

One Response to “How to Guide: Transmitting VGA Video Signal via CAT5 STP or UTP Cable”

  • izan says:
    October 5, 2011 at 7:27 PM

    I want to know CAT5e pair connection from extender to another extender?

    thanks

    Reply

    • Leave a Reply

      Similar Category

  • DIY Circuit: An Electronic Counter for your Mailbox Letters
    Electronic Counter for Mailbox Circuit DIY
    • Does the postman was coming today? or are there any letter for today? Such questions always came out of the millions of people each day. And, as...
  • DIY How to Make an Automatic Emergency Lighting Unit
    Automatic Emergency Lighting DIY Circuit
    • This automatic emergency lighting unit use NiCad batteries in the main circuit to provide a power supply which is always ready for emergency lighting during power outages....
  • How to Perform a Starter Motor Pull-In Test DIY
    starter motor pull-in test schematic
    • Please disconnect the battery ground (—) cable before removing the starting motor. And here is your starter motor pull-in test diy guideline:
  • Do It Yourself Hookup Ammeter Gauge for Internal Regulator
    ammeter gauge charging system hookup
    • An ammeter gauge may be used in car/automotive in order to exactly monitor charging system condition. Below illustration shows hookup design schematic for ammeter gauge to be...