How to Install Keyless Ignition Switch for Honda VTX1300

A keyless system can include both keyless entry system and a keyless ignition system, it is a system designed to remotely permit or deny access. The herein article will guide you on installing ARSE Keyless Ignition Switch for your Honda VTX1300.

After remove the seat, lift the ignition module off of the battery cover, remove the headlight and expose the wiring connectors inside, you will be guided with step by step for such how to disconnect the 3-pin connector that comes from the ignition switch, set the new wiring harness along the backbone of the bike with connectors (6-pin, 9-pin, 3-pin), run the new wiring harness along the right bottom side of the motorcycle back bone, set the Wireless Ignition Module and connect the connectors of the new wiring harness to the Wireless Ignition Module, how to install the antenna into the seat and connect it to the module.

Further details on Keyless Ignition Switch for Honda VTX1300 can be seen in this how-to install pdf article (source: bulletproofelectronics.com)