Home » Circuitry » Replacing Suzuki Swift Full Airbag Wiring Harness

Replacing Suzuki Swift Full Airbag Wiring Harness

Sponsored Links

Below is the figure shows the replacement of Suzuki Swift full airbag wiring section connected to the harness. The wiring harness replacement section has 2 connectors instead the original harness, as shown in purple wire.

Replacement of melted Suzuki Swift airbag module wiring harness

Since the rear of Suzuki Swift passenger airbag module reaches temperatures to melt the plug connecting the airbag to harness after firing, the fix for this condition was to replace the full airbag wiring harness.

The cut off of melted connector also shown in the figure above. (source: iagresearch.com.au)



Filed in category: Circuitry, wiring harness, suzuki, airbag, swift, by Doughary Dow at September 8, 2009
Sponsored Links

«
»
You can leave a response, or trackback from your own site.

Leave a Reply

    Similar Category

  • DIY Circuit: An Electronic Counter for your Mailbox Letters
    Electronic Counter for Mailbox Circuit DIY
    • Does the postman was coming today? or are there any letter for today? Such questions always came out of the millions of people each day. And, as...
  • DIY How to Make an Automatic Emergency Lighting Unit
    Automatic Emergency Lighting DIY Circuit
    • This automatic emergency lighting unit use NiCad batteries in the main circuit to provide a power supply which is always ready for emergency lighting during power outages....
  • How to Perform a Starter Motor Pull-In Test DIY
    starter motor pull-in test schematic
    • Please disconnect the battery ground (—) cable before removing the starting motor. And here is your starter motor pull-in test diy guideline:
  • Do It Yourself Hookup Ammeter Gauge for Internal Regulator
    ammeter gauge charging system hookup
    • An ammeter gauge may be used in car/automotive in order to exactly monitor charging system condition. Below illustration shows hookup design schematic for ammeter gauge to be...